First, do a visual inspection for ‘sagging’ locations where water will collect and pool. These areas are frequently caused by water, from a hose or rain, washing earth, foundation material and sand into a hollow space below the paver foundation. Once pooling is noticeable, these sagging locations often widen quickly do to the increase of water draining in these locations. It’s essential for the hollow to be filled and stabilized before leveling the pavers, otherwise you can be performing the same job next year. To repair this situation can be difficult. First, remove the sagging pavers, find the hollow and fill it with a foundation material. Subsequent, you want to tamp or pack the foundation material to within two inches of the bottom of the current pavers. Fill the remaining 2 inches with sand and tamp it level with the bottom of the current pavers and replace the removed pavers.Following fixing any sagging locations, look for individual pavers that are sitting higher or reduce than the surrounding pavers. A paver that sits greater can often be leveled by using a rubber mallet to force it into its proper position. If it is as well high or does not move, you may have to remove it so you can eliminate some of the sand that’s beneath the paver. If it sits low, you will have to eliminate it to add sand till it’s level. To remove the paver, you can purchase a paver removal tool or you can use a little pry bar to loosen the paver and lift it out of its space, being careful not to crack or chip the paver.If any pavers have been removed, you’ll want to sand these locations before proceeding.It is a good idea to stress wash the surface on a yearly basis. Pressure Washing cleans the surface of your pavers and also remove a lot of the organic material growing in between the pavers. Removing the organic material reduces the quantity of bugs living in your paver region and helps maintain the pavers stable.Inspect the joints of the pavers for sand loss. If the sand is more than ¼ inch beneath the joint surface, you’ll have to “re-sand” the pavers. To re-sand, you must use paver sand. You can purchase this in bags at Lowes and Home Depot or at a brick yard. Spread the sand our on the pavers and utilizing a push broom, sweep the sand back and forth at a 45 degree angle from the joint lines until the level is 1/4th to 1/8th of an inch to the top of the joint surface.Following the pavers have been adjusted, cleaned and re-sanded (and every time following re-sanding) you want to seal your pavers with a good high quality sealer. Sealing your pavers will shield the pavers from most kind staining and it will harden the joint sand, locking your pavers into location and preventing anthills and weeds from expanding in between pavers. A good quality sealer will stop a haze from forming on the paver surface caused from moisture in the paver when sealing. Take a look at some crucial, beneficial short articles regarding Pavers san diego.