This IP 192.168.1.1 could be the default Internet Protocol (IP) address for many of the house broadband routers. This IP 192.168.1.1 address was originally or initially utilized by Linksys as well as then it has been in use in various other devices which can be useful for home networking like those made by Westell, Netgear and few others.Even if this 192.168.1.254 is the default IP address for some from the modems and broadband users worldwide plus it necessarily doesn’t need to be the default address for all you broadband users. Almost all of the factories set their default Ip to 192.168.1.1 to be able to promote a standardized computing atmosphere as well as make the first time users very easy to set up their particular networks quickly.Are only able to the Linksys and also other routers use the IP 192.168.1.1 address?Definitely no, because this IP 192.168.1.1 is a private IPv4 address as well as any computer, modem, outer or some other internet devices regardless of anywhere might be configured using this IP 192.168.1.1 address. However IP 192.168.1.1 address is generally a bad idea because there are several devices that can default directly into this Ip because there may arise the difficulties of connectivity from various multiple devices which might be using the same default of IP 192.168.1.1 address. It’s very much vital that you understand that just about every internet device can have just one Ip that will be associated with that one device. Should you be using multiple devices which can be working on a single IP of 192.168.1.1 and in those multiple devices one of them should be changed to many other settings.How can this IP 192.168.1.1 address be accessed?If you want connect to the IP 192.168.1.1 address, everything you should do is usually to type 192.168.1.One in the address bar of your browser and just press enter or click using your mouse on the run link. It may or is probably not inside the best interests to train on a browser that props up Web standards for the best results. Using the browser that supports Web standard will take you directly into what the software that will essentially power your network. Here you can create your individual alterations in the settings like creating the username and passwords which enable it to also configure your device which is used for network.In the matter of any computer configuration it’s the same case and yes it always recommended in your better interest to create an entire backup of your system settings before editing them or else just jot down all of the defaults for each and every setting that you would like to improve. You could lose your web connection if the few incorrect settings are not correct while configuring your network system.Is anything goes irreparably wrong while editing the internet network device by using IP 192.168.1.1, normally you will have a reset button for the back of every network unit and in the event you press that, it is going to automatically restore the whole settings for the factory defaults.